Wittco 700-CW - Manual (Page 8)

500 & 700 CHIP WARMER F-41160 (02-13)
7
OPERATION INSTRUCTIONS
The Warmer and its
parts are hot. Be very careful when
operating, cleaning, or servicing the
warmer.
1.
Switch Power Switch to ON
position. Verify that switch
illuminates.
2. Open Top Door.
3. Pour chips into Baffle.
Do not overfill. The Top Door must
be able to fully close.
VCD5 holds approx. 22 gallons, and
VCD44 holds approx. 44 gallons of
chips.
4.
Close Top Door.
5. After approx. 30 to 40 minutes,
open Front Door to access
warmed chips.
6. Use the Chip Scoop to remove
desired amount of chips.
7. Close Front Door.
SHUTDOWN
The Warmer and its
parts are hot. Be very careful when
operating, cleaning, or servicing the
warmer.
At the end of the day, switch Power
Switch to OFF position. Follow cleaning
instructions in this manual, if necessary.
EXTENDED SHUTDOWN
The Warmer and its
parts are hot. Be very careful when
operating, cleaning, or servicing the
warmer.
Perform the following procedure to shut
down the Chip Warmer for an extended
shutdown.
1.
Switch Power Switch to OFF
position.
2. Unplug Chip Warmer.
3. Wait until Warmer cools down.
4. Thoroughly clean Warmer. Refer
to “General Cleaning” instructions
in the MAINTENANCE section of
this manual.
5. Leave all doors slightly open to
allow for ventilation.