Wittco 700-CW - Manual (Page 5)

500 & 700 CHIP WARMER F-41160 (02-13)
4
ACCESS PANEL POSITIONING:
1.
Ensure that top Baffle notches
are over carriage bolts.
2. Insert Access Panel onto the
back of the Chip Warmer. (Fig. 1)
(Fig. 1)
3. On both sides of Access Panel,
place clips into slots, then lock.
(Fig. 3)
(Fig. 2)
LEGS INSTALLATION:
1.
To install legs, carefully tip Chip
Warmer onto its side. Screw legs
into pre-drilled holes. Return
warmer to the upright position.
SCOOP HOLDER INSTALLATION:
The Chip Scoop Holder will secure up to
a 6“ wide scoop.
1.
On either the left or right side of
the Chip Warmer, loosen four
side screws one revolution.
2. Position the Chip Scoop Holder.
(Fig. 3)
(Fig. 3)
3. Tighten four side screws.
CLEANING:
The warmer should be thoroughly
cleaned prior to putting into service.
Please refer to cleaning instructions on
page 6.
LOCATION:
For efficient warmer operation, choose a
location that will provide easy loading
and unloading without interfering with
the final assembly of food orders.
The installation location must allow
adequate clearances for servicing and
proper operation.