American Electric Lighting 30 new - Manual (Page 2)

American Electric Lighting a division of Acuity Lighting Group, Inc. Conyers, GA
DRAWING NO. B63632 REV D (BACK) ©2003 ACUITY LIGHTING GROUP, INC. PART NUMBER 057-70-63632
II Medium Cutoff - Socket Position 3D
III Medium Cutoff - Socket Position 3B
Open lower door assembly by releasing front trigger latch.
Swing door open until perpindicular to upper housing. Door
hinge is keyed so door can be removed by sliding door to the
right (when facing the fixture).
Remove Lower Door Assembly:
Open lower door assembly by releasing front trigger latch.
Glass Replacement:
Replacement lens is available and provided by Thomas and
Betts. Open the fixture door and lower carefully. Rotate
rear and side lens clips until the clips clear the glass.
Remove existing glass. Slide replacement glass under front
two clips. When glass is properly in place rotate rear and
side clips until engaged with post and glass.
Cleaning & Maintenance:
The optical assembly can be cleaned with a soft, clean,
dry cotton cloth. Starter and photo control may be
maintained from the outside of luminaire without
tools. Replacement glass can be ordered from Thomas and
Betts.
Socket Adjustment:
Refer to Photometric Type and Distribution Chart for settings.
Loosen socket bracket screws, slide to new position aligning with
letter designation, tighten to 12-14 in. lbs (See Chart Below)
Access To Lamp Compartment:
Keyed Hinge
Lower Housing Removal Position
Trigger Latch
Upper Housing
Glass Clips
Front Clips