Beijer Electronics iX TxA EN - Manual (Page 12)

TxA Maintenance
3.2.5 Replac-
ing the Back Cover and/or CPU Card
The following is needed:
• A new back cover and/or CPU card
• A Torx TX10 screwdriver
Note:
Make sure to use adequate ESD protection.
Information about spare parts can be found in chapter Available Spare Parts .
Follow the steps below:
1. Power off the operator panel.
2. Remove the back cover (1) of the operator panel by removing the
Torx M3 screws (3).
Caution:
Open the operator panel slowly, taking care of the flex cable that is connecting the
Front Unit to the CPU card (5) that is mounted in the back cover (1).
3. Disconnect the display cable according to the instructions in chapter Cables .
1
2
3
1. Back cover
2. Toothed washer
3. Torx M3 Screw
Beijer Electronics, MAEN021 12