Fagor CFB-1000AIX - Manual (Page 47)

47
2 / INSTALLING YOUR APPLIANCE EN
— In outdoor evacuation mode, fit the back-
flow valve to the motor outlet (fig. 5-B). This
back-flow valve allows obstruction of air
entering from outside.
— If you are using a 125 mm diameter flue, use
the adapter supplied (fig. 5-A).
If your outdoor flue has a diameter of less
than 125 mm, you must connect your hood in
recycling mode.
— Fit the end of the flue to the motor outlet (for
recycling mode) or to the back-flow valve (for
evacuation mode).
— Fit the ventilation shafts (fig.6-A), taking
care to position them as follows if the hood is
in recycling mode, the vents must be facing
upwards so that they are visible.
— Press on the top part (B) to insert the hood
in the ventilation shaft bracket.
— The hood is supported from the first notch
(1st click).
— You may then adjust the height of the appli-
ance, pushing it up towards the ceiling (at
least 70 cm above your cooking hob).
— When the appliance is at the required
height, y
yo ou u m mu us stt tth he en n ffiix x iitt iin n p plla ac ce e w wiitth h tth he e 4 4
s sc crre ew ws s s su up pp plliie ed d (fig.7-C).
— Then fit the interior ventilation shaft in place
again and screw in the 4 screws (fig.8-D).
fig. 5
A
B
A
B
fig. 6
C
D
fig. 7
fig. 8