Fagor VCE-180C - Manual (Page 14)

13
7. CLEANING THE DUST
CONTAINER FILTER
Empty the dust container and clean the
filter after every use in order to achieve
the maximum performance of the
appliance.
1. Make sure that the appliance is not
connected to the charger before
cleaning the dust container.
2. Extract the hand-held vacuum (7) from
the appliance.
3. Remove cup as indicated in figure D.
4. Empty dust cup (8)
5. Remove cup filter as indicated in figure E.
6. Wash the filter with cold water and wait
until it is completely dry before placing it
back into the container.
N.B.: Do not put the filter in the washing
machine or dry it with a hairdryer. The
filter must only be left to dry naturally.
7. Once the filter is dry, carefully place it
back into the container (8). Never use
the vacuum cleaner without the filter.
8. Insert the container (8) into the appliance
of the hand-held vacuum (7).
CAREFUL: The suction hole must be open
and unobstructed at all times; otherwise,
the motor may overheat and become
damaged.
N.B.: It is advisable to change the dust
container filter every three to six months,
depending on use, to ensure maximum
performance of the appliance.
6. INSTRUCTIONS FOR USE
VACUUM CLEANER:
This vacuum cleaner has a foldable
handle to facilitate storage, press handle
rotation button (2) until you hear click. This
handle can be moved upwards, pressing
the handle rotation button (2), thereby
facilitating vacuuming under sofas, beds,
tables, etc. Fig F
Vacuum cleaner will not function unless
hand vac is correctly placed in its holder.
To start the vacuum cleaner, press the on/
off button (5). To turn off press the on/off
button again (5).
HAND-HELD VACUUM:
To extract the hand-held vacuum (7) from
the appliance, press the hand-held vacuum
release button (3) and pull it out as shown
in figure C. Once you have extracted the
hand-held vacuum, move the on/off switch
(5) to the I position to start it. Move the
on/off switch to the O position to stop the
hand-held vacuum. To put the hand-held
vacuum (7) back into the appliance, firstly
place the lower part into the receptacle on
the appliance and then push the hand-held
vacuum towards the appliance until it clicks
into place in the receptacle.
likewise suction capacity, you
should stop vacuuming).
- Leave a one hour cooling period
between use and charge.