Fagor REIN-652I - Manual (Page 22)

22
Once positioned, use a pencil or point to mark fi xing points, and attach the device
to the fl oor. Insert wall plugs and screws.
Having attached the device, install plugs to cover holes in feet.
636 W 2,8 A
954 W 4,2 A
1272 W 5,5 A
1590 W 6,9 A
model intensity
ELECTRICAL CONNECTION
4
A correct electrical connection must be made for the Eco-heater to function correctly. This is a
simple process, but certain conditions must be taken into account.
Electrical installation in the home
The electrical installation must correspond to the voltage indicated on
the appliance. It must be of the correct voltage and have a good earth
connection. It must comply with all the applicable legislation and you
must have the necessary power contracted with the electrical com-
pany to connect all the appliances installed.
Installing several appliances
The Eco-heaters may be simultaneously protected and connected by a common overload pro-
tector, but always make that the total current of the appliances does not exceed the maximum
permitted.
d
e
(Marking/fl oor fi xing hole)