Fagor REIN-652I - Manual (Page 23)

23
English
Installing an appliance.
The Eco-heater is supplied with a
power cable and Schuko plug.
Installing a socket: If a new
socket needs to be installed, it
is recommended that the centre
of the socket is located approxi-
mately 100 mm to the right of the
appliance, and 100 mm above the
bottom of the appliance.
Press the On/Off master switch
for the electrical current: This is
on the rear of the appliance.
a
b
c
TECHNICAL CHARACTERISTICS
5
Power (W) 636 954 1272 1590
Component number 4 6 8 10
Kind I insulation • • • •
Voltage/ Frequency (V/Hz) 230 V / 50Hz 230 V / 50Hz 230 V / 50Hz 230 V / 50Hz
Height 610 610 610 610
Sizes Width 460 610 780 910
Depth 95 95 95 95
CHARACTERISTICS
MODELS
636 W 954 W 1272 W 1590 W
The power cable must not touch the hot parts of the
radiator.
If the connection cable of the appliance should be
damaged, in order to prevent hazard it must be replaced
by a service authorised by the manufacturer.
The socket must never be located either behind or above
the Eco-heater.
IMPORTANT
b
100 mm.
100 mm.
a c