Fagor REIN-652I - Manual (Page 30)

30
The appliance is not heating up
The appliance is hardly heating up
The appliance is making a noise
Check the appliance is plugged in and receiving electrical current (turn on the master switch on
the right side of the rear of the appliance and check the display is on).
Check whether the word “ON” (consumption indicator) appears on the display. If it appears and
disappears, raise the temperature setting to increase the difference from room temperature.
This will allow the appliance to heat continuously.
If you switch off the appliance when it is hot, some noise may occur due to contraction. This is
normal and does not indicate malfunctioning.
After checking the above, if the appliance continues to malfunction you should contact an Autho-
rised Technical Service.
In case of breakdown or if
you have any queries, you
may call the user help line
on
Observe whether the word “ON” (consumption indicator) appears on the display. If it does not,
increase the temperature setting until “ON” appears.
The problem may be due to the air outlets having recently been
obstructed (with clothing or towels, for example), causing the
radiator temperature to increase and the thermostat to switch
off the power. The safety thermostat functions automatically and
the power will switch on again as soon as the appliance cools
down.
Check that your home’s power supply is of the correct voltage.
Consult the Fagor calculation program (www.fagor.com) or an
authorised Technical Service.
a
a
a
b
b
c
TROUBLESHOOTING
ECO-HEATER
TECHNICAL ASSISTANCE The Eco-heater is not equipped
with a fuse or similar element that
can be repaired by the user. In case
of breakdown you should always
contact an Authorised Technical
Assistance Service.
IMPORTANT
902 10 50 10