NaceCare Solutions AV12QX - Manual (Page 7)

7
AFTER USE, FOLLOW THESE STEPS
1. Empty solution tank.
2. Put some fresh water in the solution tank and pump this through the system. This will help
keep the pump system clean.
1. Clean the recovery dome and gasket.
2. Thoroughly rinse and drain the recovery tank to prevent odors from developing.
3. Run the vacuum motor for 1 to 2 minutes. This will help remove any moisture from the motor
fans and fan casing.
4. When storing the machine, make sure to leave the recovery dome off of the machine. This will
allow any water left in the recovery tank to evaporate into the air. This will also help prevent
odors in the recovery tank.
5. Periodically check and clean the filter for the vacuum motor. It is located below the recovery
dome.
6. Periodically clean the water filter located inside the solution tank.
7. Periodically remove and clean the brush. Remove any hair or carpet fibres that have built up
on the brush shaft of the machine as well. For this procedure, make sure that the machine
is unplugged.
MAINTENANCE
1. After 500 working hours, the machine should be brought in to be serviced. The carbon brushes on
the vacuum motor and pump motor should be replaced at this time.
2. Worn-out carbon brushes may result in damage to the vacuum motor or to the pump, which are
not covered by warranty. Replacing the carbon brushes should be done by authorized personnel.