NaceCare Solutions AVB4X - Manual (Page 4)

4
Preparation for Work
The carpet cleaning machine Sharon-Brush is designed to clean large areas of carpet and hard floor,
even without using external accessories, since the washing device is situated below the body of the
machine (see paragraph Use as a Self-contained Machine).
It is also possible to clean upholstery, inside of cars or hard-to-reach areas, by using additional
accessories, which must be connected to the machine with connecting hoses (see paragraph Use
with Accessories).
The following steps explain the necessary operations to prepare the machine for use:
1. Put the machine in the normal working position and regulate the height of the handle.
2. Fill in the lower tank (solution tank) with cold or warm water, through the filling hole, adding a 5%
of not-foaming detergent (1/2 liter each 10 liters). Higher concentrations can be used in case of
particularly dirty surfaces.
Attention: wool carpet must be washed with cold water only!
While filling the lower tank, pay attention to avoid overfilling the tank and to prevent water from going
outside the appropriate filling hole. Always keep in mind the dangers connected with the use of
electrical device.
3. Close the filling hose with the cap.
4. Insert the plug of the cable into a wall socket (see Safety Regulations).