NaceCare Solutions AVB4X - Manual (Page 6)

6
Vacuum hose
Solution hose
Use with Accessories
In this modality the machine works as a classical extractor, for which you clean a surface by using
accessories which are external to the machine body.
After filling the tanks with solution and inserting the plug in the wall outlet (see the Paragraph
Preparation for work), you need to perform the following operations:
1. Connect the machine to the wand or to the hand-tool using the solution and the vacuum
hoses. To connect the hoses to the machine, remove the vacuum hose, which connects the
upper tank to the vacuum head, and the solution hose, which connects the pump to the
spraying nozzle, situated under the machine. By doing so, Sharon-Brush becomes a classical
carpet extractor. At this point it is possible to connect the accessories to the machine, through
the special connecting hoses.
2. Switch on the vacuum motor by setting their switch to position "I", and the pump by setting the
switches to position "II". In this way the solution pump always works and it is not necessary to
keep pressed the control lever situated on the control panel.
3. To spray water you need to press the lever situated on the handle of the accessory.
Working method
As regards the use as a self-contained machine, considering a rectangular surface, we suggest you to
proceed in parallel stripes, spraying and sucking the solution at the same time. Proceed at a speed
suitable with the dirt of the surface. In case of persistent spots, you can apply locally a pure
detergent. There are also spray bottles on market, with detergents, which are specific for a particular
kind of spot. Choose high-quality detergents only in order to avoid any damage to the surface. Always
make a test in an area where an eventual damage is less visible.