NaceCare Solutions AVB9X - Manual (Page 2)

2
Safety instructions (read carefully)
Every electrical device must be used for its particular function only, respecting the manufacturer’s
instructions. Failure to adhere to the instructions could result in serious person injury, electric shock, fire
or explosion.
The nowadays machines are normally produced according to the accident prevention regulations and
are often homologated by qualified institutes for the safety, but nobody and nothing can save
irresponsible users from danger.
Please, read carefully the following points and be sure to understand everything before using the
machines. The following information signals potentially dangerous conditions to the operator or
equipment.
WARNING: Fire or Explosion Hazard.
 Do not spray water near electrical outlets.
 Do not use the machine to spray or to suck dust, corrosive liquids (acids or bases) and explosive or
inflammable liquids.
 Do not use the machine in an explosive atmosphere. This machine is not equipped with an explosion
proof motor. The electric motor will spark when powered on which could cause a flash fire or
explosion if machine is used in an area where flammable vapors/liquids or combustible dusts are
present.
 Never use flammable liquids or operate machine in or near flammable liquids, vapors or combustible
dusts.
WARNING: Electrical Hazard.
 Before putting the machine’s plug in the current socket, check that the voltage available is the same
indicated on the label of the machines.
 Be sure that the electrical system is well earthed and that it has a safety differential switch.
 Verify that the cable plug is complying with the outlet.
 Do not modify plug.
 Do not use adapters or multiple sockets, without knowing the electrical input of each user.
 If any electrical extension is used, check that it corresponds to the absorbed power of the machine
and that the connection of the plug with the socket is complying and sealed.
 Take care of the electrical cable. It must be integral and protected from water, tears and chemical
agents. Do not repair the cable in case of tears, but replace it with a new one. The cable must be
replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a
hazard.
 Do not pull the cable to drag the machine or to pull the plug out.
 Pull the plug out only when the machine is switched off.
 Do not handle the plug with wet hands.