NaceCare Solutions AVB9X - Manual (Page 7)

7
Use with Accessories
In this modality the machine works as a box extractor. After filling the tanks with solution and inserting
the plug in the wall outlet (see steps 1 and 2 of the paragraph Preparation for Work as a self contained
machine for carpet), you need to do the following:
1. Connect the machine to the wand or to the hand-tool using the dedicated vacuum hose and solution
hose. The vacuum hose must be connected to the recovery tank cover, replacing the hose going to
the vacuum head. The solution hose must be connected to the specific female coupling, replacing the
hose going to the spray nozzles.
2. Switch on the vacuum motor by setting their switch to position "I", and the pump by setting the
switches to position "II". In this way the solution pump always works and it is not necessary to keep
pressed the control lever situated on the control panel.
3. To spray water you need to press the lever situated on the handle of the accessory.
Working Method
As regards the use as a self-contained machine, considering a rectangular surface, we suggest you to
proceed in parallel stripes, spraying and sucking the solution at the same time. Proceed at a speed
suitable to the dirt of the carpet. Act on the regulation valve to set the proper quantity of water to be
sprayed on the carpet.
In case of persistent spots, you can locally apply a pure detergent. On the market there are also spray
bottles with detergents which are specific for a particular kind of spot. Choose high-quality detergents
only, in order to avoid any damage to the surface. Always make a test in an area where an eventual
damage is less visible.