NaceCare Solutions K1120T - Manual (Page 14)

14
1. Switch off the machine. 1. Switch off the machine. 1. Switch off the machine. 1. Switch off the machine. 1. Switch off the machine.
2. Cut of
2. Cut of 2. Cut of 2. Cut of 2. Cut off the water supply f the water supply f the water supply f the water supply f the water supply.....
3. Open the spray gun briefly 3. Open the spray gun briefly 3. Open the spray gun briefly 3. Open the spray gun briefly 3. Open the spray gun briefly
until the pressure is released.
until the pressure is released. until the pressure is released. until the pressure is released. until the pressure is released.
4. Apply the safety catch on the spray gun.
4. Apply the safety catch on the spray gun. 4. Apply the safety catch on the spray gun. 4. Apply the safety catch on the spray gun. 4. Apply the safety catch on the spray gun.
5. Remove the water hose and spray gun.
5. Remove the water hose and spray gun. 5. Remove the water hose and spray gun. 5. Remove the water hose and spray gun. 5. Remove the water hose and spray gun.
6. Drain the pump: switch on the motor for approx. 20 seconds.
6. Drain the pump: switch on the motor for approx. 20 seconds. 6. Drain the pump: switch on the motor for approx. 20 seconds. 6. Drain the pump: switch on the motor for approx. 20 seconds. 6. Drain the pump: switch on the motor for approx. 20 seconds.
7. Pull the plug from the socket.
7. Pull the plug from the socket. 7. Pull the plug from the socket. 7. Pull the plug from the socket. 7. Pull the plug from the socket.
8. Winter: store the pump in rooms above 0
8. Winter: store the pump in rooms above 0 8. Winter: store the pump in rooms above 0 8. Winter: store the pump in rooms above 0 8. Winter: store the pump in rooms above 0
°°°°°C.
C. C. C. C.
9. Clean the water filter 9. Clean the water filter 9. Clean the water filter 9. Clean the water filter 9. Clean the water filter.....
3
3
3
3
chem. Pmax
4
5
A mixing ratio of 3-5% is achieved when
the Vario-Jet is fully turned on. pH value
neutral 7-9.
Turn on Vario-Jet to reach low
pressure !
This is accomplished by turning the
handwheel. The default setting is
maximum pressure.
Adjusting the pressure
Unwind HP-hose completely.
Place chemical filter no. 5 in the
reservoir with the cleansing agent.
Turn on Vario-Jet No. 4 to to enable the
injector to induct the cleansing agent. By
turning back the Vario-Jet nozzle, the supply of
chemical is automatically cut off. Allow the cleans-
ing agent to take effect and then remove with high
pressure spray.
When using cleansing agents:
Note that you must always
comply with the instructions
provided by the manufac-
turer of the cleansing agent
(e.g. instructions concerning
safety clothing) and the water
protection regulations!
To shut down the pump:
Preparation for use Preparation for use Preparation for use Preparation for use Preparation for use
Max high pressure hose
length 20m