NaceCare Solutions RM1800H - Manual (Page 8)

7. If you are finished vacuuming and you are not going to be using the machine for a
quite while place the end of the vacuum hose into the clean water tank and suck the
clean water out of the tank. This will rinse the hose and empty the fresh water tank at
the same time. Do this before you loop the hose.
NOTE: After vacuuming the residual liquid, do not re-fill the clean water tank before
draining the recovery tank.
STEP F – BLOW DRY FIXTURES (OPTIONAL)
This optional step is used when the area cleaned is going to be in use immediately after
the above procedures are completed. Only the “touchables” need to be dried; faucets,
flushers and toilet seats.
Turn the vacuum switch on and connect the stretch blow hose to the outlet hole on the
side of the machine. When drying toilet seats work in a circular motion, from the center
out to avoid splashing.
MAINTENANCE
The POWERTEC is a machine for professional use. Problems caused by improper use are
not covered by warranty.
For proper maintenance follow these procedures:
1. After using the machine, before storing it, remove all the water from both tanks. Drain it
completely by letting the pump work and keeping the spray lever pressed. This is to clean
the spraying system of the machine, including the pump, the couplings and the nozzle
2. Clean (at least every 2 months) the water filter, removing it from the machine and rinsing
it under water.
3. Bring the machine to a service centre for routine maintenance of all the parts subject to
wear. In particular: pump and vacuum motor. There are some parts, like carbon brushes,
bearings, and so on, which must be replaced in time to avoid serious damage to the
components upon which they are assembled. This damage cannot be covered by
warranty. This maintenance should be done every 500 working hours.
NaceCare Solutions
1205 Britannia Rd. E., Mississauga, Ontario, Canada L4W 1C7
Tel: (905) 795-0122 Fax: (905) 795-0038
Toll Free Tel: 1-800-387-3210
Toll Free Fax: 1-800-709-2896