NaceCare Solutions ST580 - Manual (Page 11)

CLEANING THE RECOVERY TANK
•Open the hood (1).
•Remove the drain tube (2) from its seat. Empty the tank through the drain tube by
turning the knob a few turns and then pulling out the plug.
•Remove plug (1) from the recovery tank.
•Pull out the filter with its foam-protection unit.
•Rinse the inside of the tank thoroughly with a jet of water. Slightly lift the tank,
using its handle, to improve dirt removal.
•Put the tank back in the machine and put the plug back on the drain tube.
CLEANING THE RECOVERY TANK FILTER
•Remove plug (1) from the recovery tank.
•Pull out the filter with its foam-protection unit.
•Turn the filter inside the foam-protection unit counter-clockwise to release it and
pull it out.
•Use a jet of water to clean the walls and the bottom of the filter. Clean all parts
thoroughly and carefully.
•Replace everything by following the above-indicated procedure in reverse order.