NaceCare Solutions ST580 - Manual (Page 9)

•Set the machine up for operation.
•Check that the parking brake is released (1).
•Connect the connector to the batteries (2).
•Turn the main switch key (3) a quarter turn clockwise. The battery led display
immediately comes on.
•Press brush switch (1).
•Press vacuum motor switch (2).
•Use knob (3) to adjust water flow
•Push the lever (1) to lower the base.
•Pushing the lever, lower the squeegee assembly (2).
•(Only machines with traction motor) The machine will start to move when deadman
lever (1) is pushed forward. Check, during the first few meters of wash, that brush
pressure is adequate (see "BRUSHPRESSURE" below), that the amount of water is
sufficient and that the squeegee dries the floor perfectly. The machine will now start
to work at full efficiency until the solution water is finished. Immediately apply
emergency brake (2) on the left side of the machine whenever problems arise during
operation. This control stops forward movement by the machine. To start to work
again, after solving the problem, just raise level (2) and push deadman lever (1)
forward.
OVERFLOW DEVICE
The machine has a float that trips whenever the recovery tank is full. This causes the
vacuum float to close. In this case you should empty the recovery tank.
BRUSH PRESSURE
Use lever (1) to adjust brush pressure. There are three preset positions. The greatest
pressure is when the lever is in its highest position. Pressure should be selected
depending on the type of floor and the amount of dirt. Too much pressure causes
increased brush wear and greater energy consumption.