NaceCare Solutions ST60BT - Manual (Page 14)

14
USAGE
Figure 23
Push the flap lifting pedal when there is bulky debris to collect in order to allow its
entry and collection into the central broom. Do not keep the pedal pressed.
Periodically check the level of debris in the hopper and eventually empty it. Keep in
mind that the weight of the collected waste is proportionate to the specific weight of
the swept material. In case of heavy material such as sand, piece of soil, gravel, etc.
we suggest you do not fill up the hopper more than about 70% otherwise emptying
could prove difficult.
DUMPING HOPPER
Figure 24
1. Rotate lever “a”. counter clockwise and pull the hopper from the machine
2. Transport it to a dump area by using the handle “b” on the hopper itself.
3. For a better dust tight seal it may be necessary to clean the hopper basket with a
low-pressure air line. In case of damage or wear replace it immediately.
4. To assemble the hopper again, push it fully into place and fasten it with lever ‘a’.
AT THE END OF USE
1. Stop the machine.
2. Apply the parking brake
3. Activate the filter shaker.
4. Dump the debris hopper
5. Switch off the machine by turning the key to the OFF position
a
b