NaceCare Solutions ST765 - Manual (Page 13)

CLEANING THE RECOVERY TANK
• Open the hood and keep it lifted using its support
- Remove the drain tube from its seat. Empty the tank through the drain
tube by turning the knob a few turns and then pulling out the plug.
- Remove the tank cover, releasing it from retaining clips (l)
- Rinse the inside of the tank thoroughly with a jet of water. Siightly
liftthe tank, using its handle, to improve dirt removal. It is best to do
this after totally removing the tank from the machine.
- Put the tank backin the machine and put the piug back on the drain tube
CLEANING THE RECOVERY TANK FILTER
• Remove plug (1) from the recovery tank cover.
• Pull out the filter with its foam-protection unit.
• Turn the filter inside the foam-protection unit counter-clockwise to
release it and pull It out
• Use a jet of water to clean the walls and the bottom of the f~lter Clean
all parts thoroughly and carefully
• Replace everything by foliowing the above indicated procedure in
reverse order