NaceCare Solutions ST765 - Manual (Page 5)

CONNECTING THE TRACTION MOTOR CABLE
When you receive the machine, the traction motor is disconnected to protect
other electrical parts of the machine. Connecting this wire must be done by
authorized service personnel.
CONNECTING THE BATTERY CONNECTOR
The battery connector (1) should be connected to the machine connector (2)
CONNECTING THE BATTERY CHARGER
The battery connector (1) must fit in to the corresponding connector on the
battery charger. The battery charging connector is packaged inside the
manual bag when the machine is received. The battery charging connector
must be installed on to the battery charger as per instructions.
BATTERY CHARGING
To avoid permanent damage to the batteries, they should never be
completely discharged. When the battery meter starts to flash “0”, return the
machine to the charging station and connect the battery charger.
NOTE: Never leave the batteries in a discharged state, even if the machine
is not being used, make sure that the batteries have a charge in them.
NOTE: For Wet Lead Acid batteries, only distilled water can be used to
top them up.
BATTERY LEVEL INDICATOR
The battery level indicator shows the charge remaining in the battery pack
as follows.
4: Fully charged
3: ¾ of charge remaining
2: ½ of charge remaining
1: ¼ of charge remaining
0: Batteries need to be recharged.