NaceCare Solutions ST885 - Manual (Page 14)

CLEANING THE SQUEEGEE
The squeegee must be in perfect working condition to achieve a good
drying process. It must be clean and its rubbers must be in good condition.
Proceed as follows to clean the squeegee:
• Remove it from the machine by pulling pin (1) out from column (2).
Clean the interior with a jet of water.
• Loosen knobs (3), remove block (4) and check that there is no dirt inside.
• Check the condition of the rubbers and reverse or replace them as
necessary.
• Replace everything on the machine.
REPLACING THE REAR SQUEEGEE RUBBER
The drying edge can be changed if the squeegee rubber is worn and does
not dry properly:
• Use a hammer to push and rotate lock plates (1) in the directions
indicated by the arrow.
• Pull out the rubber-pressing blade and the rubber.
• Turn the rubber over or replace it if necessary.
• Check the height of the squeegee, Adjust using knobs (2) as necessary.
• Replace everything by carrying out these procedures in reverse order.
REMOVING THE BRUSHES
- Push lever (1) down to raise the base
- Turn key (2) to OFF and remove it from the control panel (removing the
brushes with power on may cause Injury to the hands).
- Rotate the brush, with the base raised, until it exits from the brush-
bearing plate as illustrated. The picture shows the direction of rotation for
releasing the right brush. Rotate in the opposite direction for the left
brush.