NaceCare Solutions ST885 - Manual (Page 9)

WORK
- Set the machine up for operation.
- Check that the parking brake is released (1).
- Connect the connector to the batteries (2).
- Turn the main switch key (3) a quarter turn clockwise. The main green
signal lamp (4)
- Press brush switch (1)
- Press vacuum switch (2)
- Use lever (3) to adjust water flow
- Push lever (1) forward to lower the base
- Lower the squeegee by pushing lever (2) forward
The machine will start to move when directional lever (1) is pushed
forward. Check, during the first few meters of wash, that brush pressure is
adequate bee "BRUSH PRESSURE below), that the amount of water is
sufficient and that the squeegee dries the floor perfectly.
The machine will now start to work at full efficiency until the solution
water is finished.