Varad ILS200 / ILS300 - Color Changing Interior Lighting System - Manual (Page 9)

Install the Digital Controller inside the vehicle. Find a location that
will allow all the wires to the LED lightbars to connect without
binding. The location should be 36” from where you decide to
install the wired remote control. The wired remote control should
be installed in a location within reach of the driver. For use of the
RC100 (optional with ILS200) make sure you have a direct line of
eyesight for the infra red remote reciever.
Installation of Controllers
9 6
Wiring Schematic Continued
Connect wiring harness as indicated below:
• Red wire - Battery Positive
• Black wire - Negative (ground)
• Yellow wire - Ignition (+12v when ignition is “ON”)
• White wire - Network (See “Networking pg 14”)
• Blue wire - Positive speaker terminal
• Orange wire - Positive +12v trigger from Alarm system
or courtesy light
When all controllers and LED lightbars are installed you can proceed
to plug all connectors into the ulx310C controller. Proceed to the
“Operation of ILS” section.