Boot the installed loadmaster, Configure the loadmaster, 1 boot the installed loadmaster – KEMP R Series User Manual

Page 7: 2 configure the loadmaster

Advertising

LoadMaster for the Dell R-Series
LoadMaster for UCS Installation

Installation Guide

2.1

Boot the Installed LoadMaster

The server is now ready to be rebooted with the LoadMaster software installed on the local disk.
Within the console, select the Ctrl-Alt-Del option from the Macros drop-down menu.

The server should now begin to boot from the local disk.

Occasionally, call trace code may appear while the LoadMaster is booting

up. This can be ignored.

The LoadMaster should obtain an IP address via DHCP, please note this value.

If the LoadMaster does not obtain an IP address via DHCP then the LoadMaster must be manually
configured using the console once the license key has been obtained.

Please refer to Section 3 for further information regarding manually configuring the LoadMaster.

Figure 2-2: LoadMaster Installation Complete

2.2

Configure the LoadMaster

The LoadMaster must now be configured to operate within the network configuration.

1. In an internet browser, enter the IP address that was noted in Section 2.1.

Ensure to enter https:// before the IP address.

Advertising