Martin Universal Design U-9601 LEGACY FAMILY EASEL - Manual (Page 3)

STEP 1. Assembling Legs.
Take each Upper Leg [C] (make sure
hinges are positioned on top) along with
each Lower leg [D].
Insert a 2” Bolt [ I ] through inside of upper
leg and through lower hole and then
through channel of lower leg part [D].
See FIG 1.
Secure with washer [K] and wing nut [J]
provided. See FIG 1B zoom. Repeat on all
3 remaining legs. Note: Channel in lower
portion of leg is for height adjustment
of easel.
Pg. 3
C
STEP 2. Assembed Legs.
You should now have two Assembled Legs as shown
below in FIG 2.
FIG 1
FIG 1B
FIG 2
STEP 3. Attaching the Chalkboard Surface [A].
Begin by laying the assembled legs down onto a flat
carpeted surface. Insert a 1-5/8” bolt [ L ] through each
of the two holes at the top of the upper legs See FIG 3
and two 1-5/8” bolts [L] in the lower holes of the upper
legs. See FIG 3B. Insert from the inside of the leg going
through the hole and out the front of the leg. Continue by
laying the chalkboard [A] surface over the 4 bolts & by
lining up the holes in the surface. NOTE: The green side
of the chalkboard surface should be facing outward.
FIG 3
FIG 3B
STEP 4. Attaching the Chalkboard Surface, con’td.
After the chalkboard is placed over the [4] bolts [ L ] &
[L], continue by adding one of the cross supports [F] to
the top section of the chalkboard. See FIG 4. After the
cross support is in place. Secure by using one wooden
knob [M] for each of the 4 bolts on the chalkboard
surface. NOTE: No washer is needed. See FIG 4B.
FIG 4
A
FIG 4B
F
A
A
M
L
C
D
D
C
C
D
D
D
D
C C
L
L
L
C I
F
Rev June 08 RPI