Martin Universal Design U-9601 LEGACY FAMILY EASEL - Manual (Page 4)

Pg. 4
STEP 5. Attaching the Surfaces
The images below show how the wooden knobs [M] on
all four bolts should look after proper assembly.
See FIG 5.
REPEAT STEPS 3 - 5 for the White Drawing Surface.
Please Note the White Drawing surface is the shiny
white side. This side would face the outside of the easel.
FIG 5
C
A
STEP 7. Attaching Material Tray [E], con’td.
The images below show a zoom of the correct location
of the holes that are used for the assembly of the
materials tray. See FIG 7.
STEP 6. Attaching Material Tray [E]
NOTE: 2 People needed for this step.
Move the legs in to make the easel narrower to allow
the material tray [E] to slide down over the easel into the
proper position. As one person holds the tray, the other
can line up the holes in the sides of the upper portion
of the legs. Insert one 2-3/8” [H] bolt through each hole
and secure with washer [K] and wing-nut [J]. Repeat on
other side of easel. See FIG 6.
FIG 6
E
D
STEP 8. Add Paper Roll Holder [G] & Paper
Slide paper roll over wood roll holder [G] and then insert
ends of paper roll holder into slots found on upper
portion of easel legs. See FIG 8.
Note: Insert paper edge down between cross support
and dry-erase surface to hold paper in position during
use of paper.
A
C
D
M
M
This image is the upper portion of
the surface.
This image is the lower
portion of the surface.
FIG 7
C
E
Attach
washer [K]
and wing-nut
[J] here.
C
G
F
Martin/F. Weber Co. • 4444 Lawton Avenue, Detroit, MI 48208 USA
Tel:(313)895-0700 • Fax:(313)895-0709 • E-mail:[email protected]
www.MartinUniversalDesign.com • www.weberart.com
Made in China
C
FIG 8
H H
H
H K
J
Rev June 08 RPI