APTech Series AK M60 - Manual (Page 5)

AK M60 Manual P/N 00-15000012 Rev 1
Page 5 of 13
3. TECHNICAL SPECIFICATIONS
3.1. AK M60 Specifications
3.1.1. Physical
Dimensions are approximately 6-1/2 inch wide by 6-1/8 inch high by 8-1/2 inch deep
Weight is approximately 5 lbs.
Recommended to be panel mounted in 1-27/64 (1.42) inch diameter hole
3.1.2. Pressure and Flow
3500 psig maximum inlet pressure (can be limited by inlet gauge range)
250, 150, and 100 psig nominal outlet pressure options (specified when ordered)
75 slm nitrogen maximum flow at 200 psig minimum inlet pressure (higher flow rates may be
obtainable depending on inlet pressure and system components)
3.2. AK M60 Facility Requirements
The following is needed to install the AK M60 manifold at the users facility.
1/4 inch NPT adapters
Secure mounting of the AK M60 to prevent loosening of fittings during operation of the knob
The recommended method of mounting the AK M60 manifold is with the panel mount feature. The panel
mount feature requires a 1-27/64 (1.42) inch diameter hole in a .30 inch maximum thickness panel. The
rear bonnet of the regulator is placed through the panel and secured in place with a panel nut as shown in
Figure 2. Alternately, it is possible to design a custom bracket that could secure the AK M60 manifold to
a fixed object.
The following is recommended for proper operation of the equipment:
Check valve for installation between each supply cylinder and each AK M60 inlet port
Manual valve for installation between cylinder and check valve
Appropriate purge and vent system for hazardous gases
Relief valve for installation on outlet delivery line