Goulds Pumps ANSI FAMILY IOM (ATEX Compliant) - IOM - Manual (Page 64)

7. Remove outboard labyrinth seal (332A) from
bearing housing (134). Remove O-rings (497F),
(497G) if necessary (Fig. 65).
NOTE: Labyrinth oil seal O-rings (497F, G) are
part of 3196 maintenance kits or can be obtained
separately.
8. Remove bearing locknut (136) and bearing lock
washer (382) (Fig. 66).
9. Remove inboard bearing (168A).
10. Remove outboard bearing (112A).
NOTE: When pressing bearings off shaft, use
force on inner race only.
NOTE: Save bearings for inspection.
DISASSEMBLY OF POWER END - LTX
1. Remove clamp screws (370C). Back off jam nuts
(423). Tighten jack screws (370D) evenly, this will
start bearing housing (134) out of bearing frame
(228A) (Fig. 67).
2. Remove shaft assembly from bearing frame
(228A).
62
ANSIFAM IOM - 5/08
Fig. 64
Fig. 65
Fig. 66
Fig. 67