Golight HELIOS Thermal Imaging Camera - Manual (Page 12)

9
over the front of the mounting plate . First pull the camera backwards, then
seat the back of the camera on to the mounting plate . Displace the back of
the gasket, line up the hole and install the vise screw (provided) . Tighten the
vise screw using a Phillips head screwdriver . Replace the gasket to finalize
the installation .
Wireless Remote Controls:
The wireless remote control units included are one dash mount and one
hand-held . They use buttons to perform the on/off and pan/tilt functions of
the camera . All systems have a main on/off switch for the camera itself . It
is suggested that the Helios camera be turned off until it is needed; this will
save power consumption and unnecessary draw on the battery . There are
also buttons for fast/slow operation of the pan/tilt mechanism of the system .
The Turtle Button is the slow function and the Rabbit Button is the faster func-
tion for the camera . To install the dash mounted wireless remote, remove the
cover and install four screws into the mounting holes and replace cover . The
On/Off button should be at the left side of the remote .