Golight HELIOS Thermal Imaging Camera - Manual (Page 15)

12
Hard-Wired Remote Controls
The remote control has Red (+) and Black (-) power leads for the camera
system . It is recommended that these be joined using the appropriate auto-
motive or marine grade wire attachments . Each remote needs to be wired on
a single dedicated circuit and the power be fused at a minimum of 5 amps . It
is also recommended that the power wire be connected to an ignition circuit
or a separate on/off toggle between the camera and power source . Once the
power leads are attached, the 20’ wire harness needs to be attached to the
appropriate 2 and 4 pin connectors to connect with the camera .
The 25’ BNC Cable includes a BNC to RCA adapter for adaptation to a wide
variety of displays . The BNC cable needs to be attached and locked into the
camera’s BNC jack and then run to the display that is used . *Note: If a display
is included, please see the instructions for mounting and wiring the display .
Display and Camera must be wired to separate power circuits for proper
installation .
See “Attaching the camera to the mounting plate” on page 8