Nstallation, Side view of cabinet plan view, Bb24 m – Glastender Vertical Door Coolers User Manual
Page 7
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 800.838.0888 / 989.752.4444 • www.glastender.com
6
Cleaning Instructions continued from page 3
PROCEDURE:
1. A non-chlorine based cleaner or mild detergent and warm water applied with a soft cloth or sponge to all contact sur-
faces.
2. Immediately rinse off cleaning agent(s), using clean warm water, clean soft cloth or sponge.
3. Dry with a soft clean cloth, removing standing water as soon as possible.
NOTES:
1. Never use hydrochloric acid, wire brushes, steel wool, scrapers, or chlorine based cleaners on stainless steel surfaces,
since they will break down the passivity layer and allow corrosion to occur.
2. On stainless steel surfaces, you may use a soft bristle brush or Scotch-Brite® pad for more stubborn stains. Always
scrub with the direction of the grain. Follow with a thorough cleaning as described above.
3. Deposits from food preparation must be properly removed. Even hard water deposits will rust stainless steel, if not
removed.
4. Repeated cleaning may dry up black-vinyl-clad steel (exterior) surfaces of the cooler. Armor All® or similar product
can bring back the shine. Apply the product to a cloth and then rub into the surface, rather than spraying it directly onto
the black-vinyl-clad surface.
5. The cooler door gaskets are most often overlooked when cleaning. Failure to clean them regularly will lead to prema-
ture failure, since alcohol and moisture build-up breaks down the gasket material.
s
ealing
V
ertical
D
oor
c
ooler
to
f
loor
21"
24"
SWING WILL
CONTINUE IF
NO CABINET
TO IMPEDE
8 1/2"
10"
AIR FLOW
COMPRESSOR
COMPARTMENT
7"
EVAPORATOR
HOUSING
8"
8"
1 1/2"
MINIMUM CLEARANCE
FOR AIR FLOW
WARNING:
COMPRESSOR FAILURE DUE
TO RESTRICTION OR
BLOCKAGE OF AIR FLOW WILL
VOID
WARRANTY.
180° SWING
i
nstallation
Side View of Cabinet
Plan View
COOLER
DOOR
COOLER CABINET
1" BASE
BEAD SEALANT
FLOOR
MAGNETIC GASKET
To comply with NSF & health codes, the cooler base must be
sealed to the floor using NSF listed sealant. Place a bead of
sealant along outer edges of the base and remove excess with
disposable towel. The floor sealing procedure does not apply
to models that include legs or casters.
bb24 M
iniMuM
a
ir
f
loW
c
learance
D
iagraM