Nyrius ARIES Matrix - Manual (Page 12)

- 12 -
ISSUE LED POSSIBLE SOLUTION
Transmitter/
Receiver LEDs
are not ON
• NO LEDs
• Confirm that Transmitter/
Receiver are correctly and firmly
connected and plugged into
power outlet.
No video is
displayed
• POWER LED
FLASHING BLUE
• OSD SHOWING
"Searching
available channels"
• Transmitter/Receiver may
require a few seconds to
connect.
• Ensure the correct HDMI/
Composite video input is
selected on your TV.
• Please confirm that your HDMI/
Composite video cables are
properly connected.
• Check that your video resolution
with device in HDMI input is set
1080p, 1080i, 720p, 576p, or
480p
• Enable Extend Mode
• POWER LED
IS SOLID BLUE
+ INPUT LED
FLASHING BLUE
• OSD SHOWING
“No signal”
• Check that proper cables
are connected between the
transmitter and your AV
devices.
• Ensure your source devices
connected to the Transmitter
are powered on.
• Ensure the proper cables are
connected between the receiver
and your 2nd HDTV near the
Receiver.
• Enable Extend Mode
Poor picture
quality or
intermittent
video • POWER LED IS
SOLID BLUE +
INPUT LED SOLID
BLUE
• Check that your video resolution
with device in HDMI OR
Component input are set to
supported resolutions.
• Press CHANNEL 2 times on
remote control to manually
change the wireless channel.
• Ensure the transmission distance
is less than 66 feet (LOS).
• Enable Extend Mode
TROUBLESHOOTING