Edsal 3006 - Manual (Page 3)

Assembly Instructions : Edsal 3006KA & 3007KA Series Storage Cabinets Page 3 Assembly Instructions : Edsal 3006KA & 3007KA Series Storage Cabinets Page 3 Assembly Instructions : Edsal 3006KA & 3007KA Series Storage Cabinets Page 3
Step 3 - Bottom Assembly
Attach the bottom to the cabinet. Place the bottom
into the interior of the assembled unit and insert the
rear and side flanges of the bottom into the tabs of the
back and side panels by pushing the bottom squarely
down. The front flange of the bottom will install over
the return flange of the door frame kick plate (see fig-
ure 3 for reference).
Figure 3 - Bottom Assembly
Door frame
Tabs located on the
front flange of sides.
(opposite side also)
Bottom front flange
installs over flange
of kick plate.
Bottom
Side flanges to attach
bottom to sides.
(opposite side also)
Back flanges to attach
bottom to backs.
Figure 4 - Top Assembly
Top
Tab locations for
top to sides
(opposite side also)
Tab locations for
top to back
Holes for tabs located
on the under side of
the frame.
(opposite side also)
Door frame kick
plate flange.
(
Bottom installs over flange)
Door frame locking tab.
Push down to lock.
(opposite side also)
Figure 2 - Door Frame Assembly
Hole locations for top to unit.
(opposite side & back also)
Step 4 - Top Assembly
Place the unit upright and place on a level surface
to insure the unit is square. Now to install the top.
Place the top over the assembled unit. The top will
fit over the assembled unit allowing the inside of the
top bracket holes to properly align with the tabs
located on the inside of the back and sides. After
assuring that the tabs and holes are aligned, push
down on all outside edges of the top to snap the top
into place (see figure 4 for reference.)
Step 2 - Door Frame Assembly
Take the door frame assembly and fasten it to the
sides. Place the rectangular holes located on the
rear of door frame into the tabs located on the front
flange of the side panels (if necessary, push tabs
slightly out to assist in the engagement process).
Open one door at a time to see if all tabs on both left
and right side panels are inserted and aligned to the
rectangular holes of the frame (doors are not
shown in the picture to assist in the graphic il-
lustration), then slide the frame down so that all the
tabs fully engage. Next locate the locking tabs on
the top ends of the door frame. Using a screw
driver, push down on the locking tabs to prevent the
door frame from moving out of place. (see figure 2
for reference).
NOTE : DOORS ARE NOT SHOWN IN GRAPHIC
FOR ILLUSTRATION PURPOSES.