Edsal 3006 - Manual (Page 4)

Assembly Instructions : Edsal 3006KA & 3007KA Series Boltless Storage Cabinets Pa Assembly Instructions : Edsal 3006KA & 3007KA Series Boltless Storage Cabinets Pa Assembly Instructions : Edsal 3006KA & 3007KA Series Boltless Storage Cabinets Pa ge 4 ge 4 ge 4
Step 5 - Shelf Assembly
The unit is now ready for the shelves. Holding the shelf,
notice there are square and round cutouts on the edge of
the part. The square cutouts will install to the back of the
unit, and the round to the front. First select a level for
the shelf by selecting a set of square notches located
inside the unit on the back left and back right sides. A
series of round holes are located on the inside of the left
and right hand side panels near the hinges. Using a
shelf clip, insert the upper notch into a round hole oppo-
site the selected square holes where the shelf is to be
located. Push and “snap” the lower notch of the clip into
place using the next lowest round hole. Repeat the shelf
clip installation on the opposite corresponding side. To
insert the shelf, place the end with the square cutout to
the rear of the unit. Angle the shelf so that the shelf will
engage the square notches on the back and lower onto
the front shelf clips. Repeat the process for all remaining
shelves.
Figure 5 - Shelf Assembly
Upper notch
Lower notch
Shelves
Figure 6 - Final Assembly Step 6 - Final Assembly
To complete the unit, the locking handle needs to be in-
stalled on the right hand door. Follow the assembly in-
structions as written on the handle hardware bag. Help-
ful hints on installation: The door rods will slide into
small plastic guides on the door. Install the handle to the
right hand door, then place the cam in position. Slide the
tip of the door rod into the lower plastic guide and posi-
tion the door rod onto the pin located on the cam and
hold it in place. Install the other door rod in the upper
plastic guide and position onto pin located on the cam.
Install the remaining hardware. If the cabinet is not lo-
cated on a level surface, two (2) leg levelers have been
supplied. Install the cage nut over the holes located in
the bottom front of the kick plate, or on the bottom back
return flanges of the sides. Install the threaded leg lev-
eler into the nut, and adjust as necessary.
Right Hand Door
Handle Location
Front Leg Leveler
Holes located
On Bottom of
Cabinet at these
Points
Rear Leg Leveler
Holes located On
Bottom of Cabinet
at this Point
(opposite side also)