Rugged Ridge Heavy Duty Tire Carrier Mount, 87-06 Jeep Wrangler - Manual (Page 3)

Page 3 of 3
6. Hang the Tire Carrier on the Angle Bracket. Fasten to the tailgate in the original bottom holes using
original hardware. Fasten to the Angle Bracket using (2) M8 Bolts, (4) M8 Flat Washers, (2) M8
Lock Washers, and (2) M8 Nuts. Once in place, Tighten all fasteners.
7. If applicable, route third brake light wiring through large slot in top of Tire Carrier, and place brake
light assembly on top of Tire Carrier. Use (4) M8 Bolts, (8) M8 Flat Washers, (4) M8
Lock Washers, and (4) M8 Nuts. Once all are in place, tighten them. Re-route wiring and plug it
back into contacts.
Congratulations on the purchase and installation of another fine Rugged Ridge product!
© Copyright 2009, Omix-Ada
Omix-Ada Inc.
460 Horizon Dr. Suite 400
Suwanee, Georgia 30024
8. Replace Spare Tire.