Aluminum xhd & all terrain bumper series – Rugged Ridge XHD Aluminum Front Bumper, Non-Winch Mount User Manual
Page 4
Copyright © 2013 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 4/8
Aluminum Hoop Over rider (11541.14)
NOTICE: Over rider installs easier with bumper detached from vehicle
Contents:
1. Aluminum Hoop Over Rider (1)
2. M6 Hex Bolts (8)
3. M6 Washer (16)
4. M6 Nylock Nuts (8)
ALUMINUM XHD & ALL TERRAIN BUMPER SERIES
1. Remove Aluminum XHD bumper or All Terrain
bumper if previously installed. Twist plug at rear of
fog light to disconnect wiring. Slide the bumper off
frame.
2. Position over rider on top of bumper with hoop
leaning forward. Align mounting holes with
slotted cutouts on the XHD Aluminum Bumper, or
with 4 holes on All Terrain Steel Bumper (remove
pre-installed rubber plugs from holes on All
Terrain steel bumper). Install using M6 hardware.
3. Follow bumper instructions to reinstall bumper
and over rider. Reconnect light harness to fog
lights.