Rugged Ridge XHD Aluminum Front Bumper, Non-Winch Mount - Manual (Page 6)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
ALUMINUM XHD & ALL TERRAIN BUMPER SERIES
Page 6/8
1. Remove factory front bumper. Twist plug at rear
of fog light to disconnect wiring. Unscrew fog lights.
Aluminum XHD & All Terrain Front Bumper (11541.01/.02 & 11542.01/.02)
NOTICE: Some accessories may need to be installed to center section before installing on vehicle
Contents:
1. Bumper Shell
2. M12x60 Bolt (8)
3. M12 Washer (8)
4. M12 Nut Plate (4)
5. Sheet Metal Screws (8) 6. M8 Flat Head Bolt (4)
7. M8 Washer (4)
8. M8 Nut (4)
9. Cover Plate
2. Install factory fog lights into center section using
sheet metal screws.
3. Attach cover plate to center section using
M8 hardware.