Rugged Ridge XHD Low/High Mount Snorkel System, 07-11 Jeep Wrangler (JK) User Manual
Page 14
Page 14 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
80
- Reinstall factory upper
air box removed in
step (41). Rotate air
hose back to upper air
box and connect 3”
clamps. Clamp upper air
box to lower air box and
reconnect air vent tube.
Check that upper and
lower air box are seated.
79
- Reinstall air filter
removed in step (41).
It is recommended that
a high flow air filter be
used. Either a washable
(oil free) design like
Rugged Ridge P/N:
17752.05 or K&N oil
type can be used.
77
- Using a file or Dremel
tool cut away plastic
material until clamp
moves freely.
76
- Inspect top inner air
box clamp. If clamp is
rubbing or making
contact with top of
grommet mount (arrow)
the mount will need to be
clearanced. If clamp
moves freely proceed
to step (78).
78
- Test fit factory upper
air box to lower box and
check alignment. All
clamps should move
Freely and latch to
correct points on upper
box.
81
- Tighten all clamps
and inspect sensor
connections. Air sensor
must be inplace before
vehicle is started.