Rugged Ridge Cold Air Intake Kit, 2.5L, 91-95 Jeep Wrangler (YJ) - Manual (Page 2)

Page 2 of 3
3. Remove hose connecting the power steering fluid reservoir to the steering box. Replace it with the longer
Power Steering Hose supplied and secure with 1/16” Hose Clamps. Install Edge Trim onto Heat Shield and trim
to length. Install Rubber Isolator Mount into slot in the Heat Shield using supplied M8 hardware.
4. Install Heat Shield by inserting the two tabs behind the radiator shroud. Use the factory Phillips head screws
removed in step 2 to reinstall the shroud and Heat Shield. Secure the bottom of the Heat Shield to original
air filter housing bracket using the provided M6 hardware. Relocate the power steering fluid reservoir to the
provided mounting location on the heat shield. Check all hoses for clearance around Heat Shield. Use
provided 1/4-20 hardware and metal (2) Spacers for installation.
5. Install small end of Rubber Elbow onto throttle body using supplied #40 Hose Clamp. The Rear Intake Tube
can than be installed onto the large end of the Rubber Elbow using a #48 Hose Clamp. On the end of the rear
intake tube, install the Rubber Tube Coupler using a #48 Hose Clamp. Place the #56 Hose Clamp on the large end
of the Rubber Tube Coupler to prepare for the installation of the Front Intake Tube.