Rugged Ridge Throttle Body Spacer, Rugged Ridge, Jeep Wrangler (JK) 07-11 3.8L User Manual
Page 2
P
age 2 of 2
5.
Tighten bolts in a crisscross pattern to 8 ft lbs.
NOTICE! Do not overtighten the
bolts. If the bolts are overtightened
the throttle body will crack!
4.
Place the gasket on the backside of the throttle body followed by
the spacer (Logo up, rounded edge to the right). Place the supplied M6
bolts and washers through the front of the throttle body going through
both the gasket and throttle body spacer.
Take the assembly and place the lower right bolt into the intake manifold
and then rotate and align the assembly placing the other bolts into the
intake manifold.
6.
Reconnect electrical connector to the bottom of the throttle body;
install the air inlet tube followed by the air intake temperature sensor.
Tighten all hose clamps.
For assistance, please contact Omix-ADA Technical Support department
(770) 614-6101