Rugged Ridge Upper Soft Door Kit, Front, Black Diamond, 07-14 Jeep Wrangler (JK) - Manual (Page 5)

P age 5 of 6
Door Seal Adjustment Procedures (Rear Doors)
Pic. 28 Pic. 29 Pic. 30
Pic. 25 Pic. 26 Pic. 27
19. Open half door and grab the excess weather-stripping closest to the Windshield frame. Place the weather
stripping behind the post of the soft upper frame (Pic. 25). Adjust as needed to fill gap between windshield
frame and upper door .
20. Trim rear weather-stripping so that it slightly overlaps the weather-stripping of the half door (Pic. 26 -27).
21. Rear upper door frames are installed using the same procedures and techniques discribed in steps (2-19).
22. Apply Velcro to lower doors as described in step (2). Velcro should be positioned 1/8” from the top of lower
1/2 door. Press Velcro firmly into place to ensure good adhesion (Pic. 28).
23. Position rear upper frames onto lower doors. Top corners should have a 1/8” gap between the top of
upper door and soft top (Pic. 29). Adjustment of rear upper doors will be the same as fronts. See steps (4-12)
for proper alignment procedures.
24. After upper doors have been positioned correctly with 1/8” gaps check for visible light from inside vehicle.
If light is visible rear upper doors should be adjusted in the same manner as the fronts (Pic.30).
See steps (14-19) for proper alignment procedures.
25. When bending frames small adjustment should be made. (DO NOT OVER BEND) Continue to make small
adjustments until a tight seal has been made around door opening.