Rugged Ridge All Terrain Fender Flares, 09-12 Ram 1500 Trucks - Manual (Page 3)

Page 3 of 3 Rev. 11/10 SB
81630.42
Step 8. Install the rear flare using the factory hardware
previously removed. Use one of the supplied phillips
head screws in the area indicated by the small arrow.
Slight pressure against the outside of the flare pushing
towards the vehicle will be needed for installation.
Repeat this procedure for the other rear flare.
Optional Painting Instructions
NOTICE: Do not use any harsh chemicals on flares. Use only plastic approved cleaning chemicals.
Paint Preparation:
1. Lightly sand flares with 320 grid sandpaper.
2. Remove all surface contaminants from flares using
an approved grease and wax remover.
3. Wipe flares with a tack rag to remove any dust or dirt.
Painting:
1. Apply two even coats of adhesion promoter to flares.
Allow recommended flash time between coats. Let
second coat dry for 15 minutes before primer
application.
2. Apply an even coat of primer to flare surface. (A high
build primer is recommended)
3. Paint flares with a automotive grade paint. (A flex
additive must be added to paint)
For Technical Assistance Contact:
OMIX-ADA Tech Support
Phone: 1-800-449-6649
Email: [email protected]
Web: www.Omix-Ada.com