Rugged Ridge Hurricane Flat Fender Flare Kit, 07-14 Wrangler - Manual (Page 4)

460 Horizon Drive #400 | Suwanee, GA 30024 USA | www.omix-ada.com | Copyright © 2013 Omix-Ada ® , Inc.
Page 2/8
1. Remove the front & rear factory fender flare, flare support and
wheel liner.
Remove factory fasteners with a flat head screw driver or similar.
2. Cut side marker off 2 inches from the base of light fixture.
3. Strip 1/4” from wires previously cut. Strip 1/4” from both ends
from wires supplied in hardware kit.
Splice wires cut using the butt connectors and wires supplied.
Hurricane Flat Fender Flares
PATENT PENDING
11640.10