Rugged Ridge Pocket Island Topper, Black, 10-14 Jeep Wrangler Unlimited (JK) - Manual (Page 3)

Jeep® JK Wrangler Roll Bar Island Topper ( 4DR)
Page 3 of 3
(Step 10) - Secure roll bar flaps as shown. Flaps have been designed to work with roll bar grab handles.
Grab handles should be positioned between flap cutouts.
.
(Step 12) (Step 13) (Step 13)
(Step 10)
(Step 10) (Step 11)
(Step 12) - For vehicles without plastic door surrounds follow steps 1-6 as described. Steps 7 & 8 are
not used. Side Velcro straps are to be pulled under roll bar as shown.
(Step 13) - Pull Velcro strap over top of roll bar and twist so that Velcro face can be secured to front
side of strap as shown. Pull side straps down to body tub and tighten.
(Step 14) - With all Velcro straps secured proceed with steps 9-11.
NOTE: Island Toppers have been designed to work best with full door surrounds installed. Tops
installed to vehicles without surrounds may not fit as tight. This is normal.
(Step 11) - With all side Velcro straps secured go back and tighten sound bar straps, side body tub hooks
and rear swivel hook straps. Pull tight until top is smooth.
Installation Instructions - Vehicles Without Plastic Door Surrounds
Part Number: 13592.XX