Audiovox ACA200 - Manual (Page 10)

Receiver Installation
The receiver must be installed in the vehicle’s trunk or interior. The receiver are not
weather proof and must be located in a dry location
Tap/Run Connection
1. Wiring the receiver connection.
a. Wiring the receiver to the vehicle. Choose a source that only has power
when the vehicle is running. Connect as shown using the tap connectors
supplied.
i. Place the unstripped ignition source wire on the run channel
ii. Place the unstripped red power wire completely.
iii. Fold the tap connector back over the wires and make the
9