Audiovox ACA200 - Manual (Page 9)

iv. Close the top hinged cover until latched.
b) Attach the black wire to the ground.
i. Place the un-stripped ground lead wire on the
run channel.
Tap/Run Connection
ii. Insert the un-stripped black ground wire completely.
iii. Fold the tap connector back over the wires and make the connection by
crimping the u-contact down flush with the plastic insulator.
iv. Close the top hinged cover until latched.
c) Reverse/Normal Image Jumper: The blue jumper wire loop is located at the
camera cable connector, installed in the harness. The camera image is pre-wired
for reverse image. If mounting the camera on the front of the vehicle, cut the
blue wire loop to change the camera image to normal. Secure cut wires with
electrical tape.
8