Australian Monitor AV Revolution - Manual (Page 6)

PAGE 4 AV Revolution Quickstart Manual
SETUP
NETWORK CONNECTION:
When the AV Revolution software is run for the fi rst time
a default connection page is launched. By clicking
File > Settings it is possible to make this page not
appear and have the software simply connect to the
last known good connection. This allows the installer to
have the software confi gured and connect automatically
as the PC starts up.
The initial connection page also allows the user to
update fi rmware and change the IP address within the
AV Revolution hardware. This can all be done from the
Setup drop menu within the title bar.
All AV Revolution units have a default IP
of 192.168.178.178.
Connection For the First Time:
It is suggested that when connecting to the
AV Revolution for the fi rst time that a crossover cable
is used straight between the unit and your PC. You
will then need to change your network adapter to
have an IP of 192.168.178.170 with a subnet of
255.255.255.0. Then all you will need to do is open
the AV Rev software and connect. Once you have
connected for the fi rst time you can set the units
IP address or change it to DHCP.
ZONE CONTROL PAGE:
The main page of the AV revolution software allows
the user to adjust all routing for a particular zone.
In terms of DSP the zone routing page is after the
input source processing but before the zone’s output
processing. All inputs within the Revolution range are
available on all outputs. This page gives the user access
to adjust basic functions such as volume, panning
and mute controls.