Rivera Primo 1056-0002 Pro Clutch (PC-10000-A) - Manual (Page 3)

3
STEP 6:
Next clutch in is a friction(as shown above) then
steel, alternating until all the plates are installed!
STEP 5:
First plate installed is the .120” steel plate. It goes
all the way to the rear of the clutch hub
STEP 4C:
Install the clutch basket/hub assembly onto the transmis-
sion main-shaft using two drops of Rivera’s Blue thread-
lock or equal and tighten the clutch hub nut to 50-60 foot-
pounds of torque.
ATTENTION!
If the clutch is to be operated in an oil bath,
it is recommended that the friction plates be
soaked in primary lubricant for 15-20 min-
utes. Wipe off excess lubricant prior to
installation.
Rivera Pimo recommends using Dextron III
ATF (Automatic Transmission Fluid) in the
primary for best performance with the Pro
Clutch.
4C
5
6
PC-1000-A PRO-CLUTCH INSTRUCTIONS_PC-1000-A PRO-CLUTCH#2A72D0.qxd 2/15/12 4:03 PM Page 3