Rivera Primo Mid-Controls - Manual (Page 11)

COMPONENT ASSEMBLY / SHIFT SIDE
1. Press two(2) each bushings (P/N 2084-0048) into shifter support tube (P/N 2084-0050)
NOTE: TRY INSTALLING WELDED SHIFT LINKAGE INTO SHIFTER SUPPORT TUBE.
THIS WILL LET YOU KNOW IF THE BUSHINGS NEED TO BE REAMED.
1. Holding shift lever mounting block (P/N 2084-0054) top front install shift
lever (P/N 2084-0053) onto mounting block lining up the top two
mounting screw holes (NOTE: THE SHIFT LEVER WILL POINT TO
YOUR LEFT). Photo 15A
2. Now install the shift lever retainer (P/N 2084-0072) with counterbored
holes facing outward. Start by installing 10-24 x 1.125” SHCS
(P/N 2100-0048) in top hole and now 10-24 x 1.125” install SHCS in
every other hole going downwards and tighten. Photo 15B
NOTE: ASSEMBLY OF SHIFT LEVER IS THE SAME AS BRAKE LEVER ASSEMBLY, EXCEPT SHIFTER POINTS TO YOUR LEFT
1. Install three(3) each pins (P/N 2101-0008) into the threaded end of
welded shifter shaft. Using a HAMMER tap the three (3) each pins until
they bottom out. Photo 21
2. Install the curved disc washer (P/N 1101-0018) onto the welded shifter
shaft, then slide on the thrust washer (P/N 1101-0020). Photo 22
3. Install the welded shifter linkage into the shifter support tube. Photo 23
4. Install thrust washer (P/N 1101-0022) onto the shaft & line-up the pin on
the welded shift linkage with the top hole on the shifter lever assembly.
Photo 24
5. Using a NO BOUNCE HAMMER give one light tap and start 5/16-18 x1.00”
SHCS (P/N 2100-0047).
Photo 15B
Photo 21 Photo 22 Photo 23 Photo 24
2084-0050
2084-0048
Line-up Hole
2084-0054
2084-0053
Line-up Hole
2100-0048
2084-0072
Photo 15A
Top Front
2101-0008
Welded Shifter Linkage
1101-0018
1101-0020
1101-0022
2100-0047
Welded Shifter Linkage
1101-0018
1101-0020
2084-0050
1101-0022